Documents

Additional commands and subcommands to be permitted during a repurposing depopulation.

A substantial block of text in ACS-6 r06 subclause 4.7.4 "Command duration limits operation" fails to discuss the Timeouts/Guidelines factors defined in new 4.7.4 subclause. Replacement text is proposed for consideration as part of the ACS-6 RFC Ballot comments resolution process.

Agenda for plenary #168 in Pleasant Hill, CA & Teleconference

In ZAC-3 r03, if any, add the error reporting requested in T10

For the g24120r1 APPROVED command similar to SECURITY ERASE PREPARE for the RESET WRITE POINTER EXT command with the ALL bit set to one, fix the error reporting to match what has been requested in T10

Meeting Announcement for August 2024 T13 Plenary #168 in Pleasant Hill, CA

Meeting Announcement for August 2024 T13 Plenary #168 in Pleasant Hill, CA

T13 Liaison report to T10

Summary of project information obtained from INCITS and related TC decisions

Meeting review of ACS-6r5

Add a command similar to SECURITY ERASE PREPARE for the RESET WRITE POINTER EXT command with the ALL bit set to one

The April T13 Plenary suggested defining a command to Device Faults. This proposal does that.

Define one Vendor Specific subcommand for each of the following commands: NCQ NON-DATA, RECEIVE FPDMA QUEUED, and SEND FPDMA QUEUED

This document proposes a method to use SCT Error Recovery Control timers for commands that are issued with no CDL descriptor, while CDL is enabled.

Specify some details that previously were left for the reader to interpret.

A mangled ACS-6 rewrite of SATA 3.5a text is causing confusion among developers.

Agenda for June Plenary

Summary of project information obtained from INCITS and related TC decisions

Add a command similar to SECURITY ERASE PREPARE for the RESET WRITE POINTER EXT command with the ALL bit set to one

Define one Vendor Specific subcommand for each of the following commands: NCQ NON-DATA, RECEIVE FPDMA QUEUED, and SEND FPDMA QUEUED

Adds a ZAC-3 SET FEATURES subcommand that allows RESET WRITE POINTER EXT commands with ALL=1 to be rejected when the host requests limitations on the use of ALL=1.

Specify some details that previously were left for the reader to interpret.

Add REQUEST SENSE DATA EXT autosense (better SCSI consistency) and use it to report current depopulation et. al operation status